Toshiba 960-498 - page 258

4.9 SD board/MDC 4 Replacement Procedures
4-34 QOSMIO F10 Maintenance Manual (960-498)
4.9.2 MDC
Removing the MDC
The following describes the procedure for removing the MDC (See Figure 4-20).
1. Turn over the SD board.
2. Remove the following screws fixing the MDC and pull the MDC straight up from the
connector CN3000 on the SD board.
• M2×4Z BIND screw x2
3. Remove the RJ11 harness from the MDC.
M2×4Z BIND
MDC
RJ11 harness
CN3000
Figure 4-20 Removing the MDC
Installing the MDC
The following describes the procedure for installing an MDC (See Figure 4-20).
1. Connect the RJ11 harness to the MDC.
2. Connect the MDC to the connector CN3000 on the SD board.
3. Secure the MDC with the following screws.
• M2×4Z BIND screw x2