Toshiba 960-498 manual Replacement Procedures VGA Heat sink, Removing the VGA heat sink

4 Replacement Procedures 4.16 VGA Heat sink

4.16 VGA Heat sink

Removing the VGA heat sink

The following describes the procedure for removing the VGA heat sink (See Figure 4-31).

1. After removing the following screws, remove the VGA heat sink.

• M2⋅4Z BIND screw x3

VGA heat sink

M2x4Z BIND

Figure 4-31 Removing the VGA heat sink

Installing the VGA heat sink

The following describes the procedure for installing the VGA heat sink (See Figure 4-30 and 4-31).

1.If there is already silicon grease on the VGA, clean it with a cloth.

Using a special applicator, apply silicon grease so that the VGA chip on the VGA is completely covered.

NOTE: Apply the silicon grease enough to cover the chip surface using the special applicator.

2. Install the VGA heat sink and secure them with the following screws.

• M2⋅4Z BIND screw x3

QOSMIO F10 Maintenance Manual (960-498) 4-47