DVFH34, DVFH34P
FIREPLACE INSTALLATION
Continued
4.Route the wire through openings pro- vided on the sides of the fireplace to a convenient location to mount your ther- mostat (no outside wall).
IMPORTANT: The wire may be short- ened but must not be lengthened.
The thermostat should be mounted 54" above the floor in a location where there is good air circulation. Avoid heat sources such as lamps, direct sunlight, fireplace, or heat and air conditioning ducts.
5.Gently remove the cover of the ther- mostat from the base. Grasp the sides of the cover firmly and pull to separate from the base.
6.Feed the electrical wires through the rectangular slots (from the back) on each side of the base (see Figure 45).
WARNING: Do not connect this thermostat to a power source. Electrical shock and/or fire haz- ard will occur.
7.Connect one bare wire end to each ter- minal (“W” and “R”) of the thermostat base (see Figure 46).
8.Install the base to the wall with screws provided with thermostat.
9.Move the temperature adjustment back and forth to insure the bimetal is free from restrictions.
10.Replace the cover onto the base. (Upon installation, the thermostat must be al- lowed to stabilize at room temperature for a minimum of 30 minutes for proper operation.)
11.Set the temperature adjustment to the desired setting.
This thermostat has been electronically calibrated at the factory. No adjustment or leveling is necessary.
Feed wires through rectangular slots
Figure 45 - Back View of Thermostat Base
| Terminal “W” |
W |
R
Terminal “R”
Figure 46 - Thermostat Base Terminals “W” and “R”
INSTALLING OPTIONAL WALL MOUNT SWITCH GWMS2
NOTICE: The GWMS2 includes 25' of wire for installation. Your fireplace includes 15' of wire for accessory installation. Choose the length that best fits your needs when installing this accessory.
1.Connect one terminal of the provided wire for the wall switch to the TPTH terminal on the valve. Connect remain- ing wire terminal to the TH terminal on the valve. Make sure that the wire terminals are in the positions on the unit as pictured in Figure 41, page 21. If wires are not connected as shown the switch will not work.
2.Route the wire through openings pro- vided on the sides of the fireplace to a convenient location to mount your switch.
3.Connect one bare wire end to each of the terminals of the GWMS2 wall switch.
4.Install the wall switch and cover in the wall.
REMOVING/REPLACING GLASS DOOR
You must remove glass door to install op- tional brick liners, logs, lava rock, and em- ber material.
CAUTION: Do not operate this fireplace with a broken glass door panel or without the glass door panel securely in place. For re- placement part information see Replacement Parts, page 33.
1.Remove the upper louver panel by lift- ing upward and out (see Figure 47).
2.Remove the screws from the three tabs at the top of the glass door while hold- ing door securely keeping it from fall- ing forward.
3.Grasp door by both sides and ease it upward off of the lower bracket (see Figure 48).
4.To replace glass door, follow the above instructions in reverse.
Top Louver
Panel
Figure 47 - Removing Top Louver Panel
Screw
Glass
Door
Assembly
Lower Bracket for
Glass Door Assembly
Figure 48 -Removing/ReplacingGlassDoor
22 | 106394 |
