INSTALLATION
Installing Battery Into Remote Installing Screen
OPERATING FIREPLACE
For Your Safety Read Before Lighting
23
INSTALLATION
Continued
INSTALLING BATTERY INTO REMOTE
1.Locate slot at bottom of remote control (see Figure 49). Firmly insert tool such as a small screwdriver, butter knife, or dime into the slot and lift up to remove cover.
2.Insert supplied battery into remote control. Positive and nega- tive are marked inside remote control casing. Note: Remote will not function if battery is not installed correctly.
3.Slide tab on cover into remote housing and snap cover back into place.
IMPORTANT: Use only A23 12 volt battery in remote. DO NOT use AAA battery.
Tab
OPERATING FIREPLACE
FOR YOUR SAFETY READ
BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop- erty damage, personal injury or loss of life.
A. | This appliance has a pilot which lights automatically when |
| using the supplied wall switch or remote control. If you |
| have a power outage, the pilot may be lighted by hand with |
| |
| lowing warnings must be followed. |
B. | BEFORE LIGHTING smell all around the appliance area |
Slot
A23 12
Volt
Battery
Cover
for gas. Be sure to smell next to the floor because some gas | |
is heavier than air and will settle on the floor. | |
WHAT TO DO IF YOU SMELL GAS | |
• | Do not try to light any appliance. |
• Do not touch any electric switch; do not use any phone in | |
| your building. |
• | Immediately call your gas supplier from a neighbor’s |
| phone. Follow the gas supplier’s instructions. |
• | If you cannot reach your gas supplier, call the fire de- |
Positive | Remote |
| Control |
Negative |
|
Figure 49 - Installing Battery |
|
INSTALLING SCREEN
Install fireplace screen by slipping notches of fireplace screen over screws on front of fireplace (see Figure 50).
Notches
Screws for
Mounting Screen
Figure 50 - Installing Fireplace Screen (EFP33PR Shown)
partment. |
C. Electric Power Outage Only: Use only your hand to turn |
the manual override handle on the gas control knob. Never |
use tools. If the knob will not turn by hand, don’t try to |
repair it, call a qualified service technician or gas supplier. |
Force or attempted repair may result in a fire or explosion. |
D. Do not use this appliance if any part has been under water. |
Immediately call a qualified service technician to inspect |
the appliance and to replace any part of the control system |
and any gas control which has been under water. |
For more
visit www.
.com
