14
INSTALLATION
Installing Blower Accessory GA3450T in
INSTALLATION
Continued
For Built-In Installation
WARNING: A licensed electrician must connect the wiring harness to electrical supply following all local codes.Electricianmustprovideaclampontheboxcover to secure the wiring. Wiring should be routed through the bushing in the hole on the outer casing of fireplace.
1.Install a snap bushing found in hardware kit into one of the holes on rear of valve cover shield. The other hole is for a strain relief clamp (not supplied) to secure incoming electrical supply.
2.Follow steps 2 through 6 in Installing Blower Accessory, page 13.
3.A licensed electrician must follow the wiring diagram to con- nect incoming electrical supply to fan kit wiring harness (see Figure 19).
4.Plug power cord to the outlet receptacle (not provided) as shown in Figure 20. Wind the extra cable in power cord and and tie it up with the plastic wire strap (see Figure 20). Set the cable bundle between the burner bracket and outer casing, away from the burner.
| Fan Switch |
|
|
|
|
|
| ||||
| (Auto/Off/On) |
|
|
|
|
|
| ||||
|
| 1 Auto |
|
|
|
|
|
| |||
| Off | 2 |
|
|
|
|
|
|
|
|
|
|
| 3 | Blue |
| Thermostat | ||||||
|
|
| On |
|
|
| Switch | ||||
|
|
|
|
|
| (N.O.) | |||||
110/115 |
|
| Red |
|
|
|
| Blue | |||
V.A.C. |
|
|
|
| Blower | ||||||
| Black |
|
|
|
|
|
|
|
| Motor | |
|
|
|
|
|
|
| Red |
| |||
| White |
|
|
|
|
|
| White |
| ||
| Green |
|
|
|
|
|
| Green |
Figure 19 - Wiring Diagram For Blower Accessory
5.Test to make sure the blower is working properly.
6.Reinstall upper louver assembly (see Figure 15, page 12) and close lower louver.
Extension Cord
Use extension cord if needed. The cord must have a
INSTALLING OPTIONAL BLOWER ACCESSORY GA3450T IN THERMOSTAT- CONTROLLED MODELS
Removing Upper Louver Assembly
To install the blower accessory, you must first remove the upper louver assembly.
1.Remove 4 screws from upper louver assembly (see Figure 21). Save these screws.
2.Pull upper louver assembly straight out from the cabinet. Be care- ful not to scratch the paint. Set louver assembly and screws aside.
Blower Bracket
Mounting Holes
Blower Bracket
Assembly
Screw
SwitchPower Cord
Switch
Plate
Blue
Red
Black
Wire Harness
Plastic Wire Strap
Lower Louver Door
Wire Harness
Outlet Receptacle (not included)
Clamp Connector (not included)
| Upper Louver |
Brass Screws | Assembly |
|
Figure 21 - Removing Upper Louver Assembly
Figure 20 - Installing Blower Bracket Assembly
For..com