Installation
Continued
INSTALLING LOGS
CAUTION: Do not remove the dataplatesattachedtotheheater base assembly. The data plates contain important warranty and safety information.
WARNING:Failuretoposition thepartsinaccordancewiththese diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
WARNING: After installa- tion and periodically thereafter, check to ensure that no flame comes in contact with any log. WiththeheatersettoHigh,check to see if flame contact any log. If so, reposition logs according to the log installation instructions in this manual. Flames contact- ing logs will create soot.
It is very important to install the logs exactly as instructed. Do not modify logs. Only use logs supplied with fireplace.
VYGF Models Only
1. Place back log #1 on grate to fit as illustrated in Figure 28. Make sure middle section at bottom of log set is seated into
2. Place front log #2 against front grate prongs as shown in Figure 28.
3. Place crossover log #3 on top of front and back logs as shown in Figure 28.
4. Install fireplace screen by slipping notches of fireplace screen over screws on front of fireplace (see Figure 30).
WARNING:You must operate this fireplace with the fireplace screen in place. Make sure fire- place screen is in place before running fireplace.
| Crossover | |
| Log #3 | |
Front | Back | |
Log #2 | ||
Log #1 | ||
| ||
Grate |
| |
Prongs |
|
ChassisBurner
Figure 28 - Installing Log Set
Burner Ports | Log Set |
Figure 29 - Installing Log Set, Top View
Notches
Screws for
Mounting Screen
Figure 30 - Installing Fireplace Screen
www.desatech.com | 17 |
