Desa FPVF33PRA Installation, Continued, FPVF Models Only, Installing Remote Receiver Unit

Installation

Continued

FPVF Models Only

1. Place one-piece log set on grate to fit as illus- trated in Figure 31. Make sure middle section at bottom of log set is seated into “U”-shaped cutout in center of chassis (see Figure 31). IMPORTANT: Make sure log does not cover any burner ports (see Figure 32).

2. Install fireplace screen by slipping notches of fireplace screen over screws on front of fireplace (see Figure 30, page 17).

WARNING:You must operate this fireplace with the fireplace screen in place. Make sure fire- place screen is in place before running fireplace.

OPTIONAL Wireless hand-held REMOTE CONTROL Accessories (HRC100 and HRC200)

Installing Remote Receiver Unit

1. Disconnect switch wires from the control valve.

2. Remove screws attaching switch plate.

3. Remove switch plate (see Figure 33). Discard after removing.

4. Install remote receiver unit onto gas log heater base using mounting clips.

5. Push clips firmly into place (see Figure 34).

6. Connect wires as shown in Figure 35.

Remote	Ignitor
Switch
Bracket

One Piece

Log Set

Screw

Middle

Section at

Bottom of

Log Set

Burner

"U" Shaped

ChassisCutout In

Chassis

Figure 31 - Installing One Piece Log Set

Burner Ports	One Piece
	Log Set

Figure 32 - Installing One Piece Log Set,

Top View

Switch Plate Wires

Figure 33 - Switch Plate and Wiring

Harness

Mounting

Clips

Remote Receiver

Figure 34 - Installing Remote Receiver

White Wire

From Receiver

Valve

Red Wire From

Receiver

Figure 35 - Connecting Wires

18 www.desatech.com 113109-01C