Installation
Continued
Assembling and attaching OPTIONAL perimeter trim (Included with Mantel Accessory)
IMPORTANT: If you are recessing the firebox in a wall, do not attach perimeter trim at this time. See
Note: The instructions below show assembling and attaching perimeter trim to fireplace.
1.Remove packaging from three pieces of pe- rimeter trim.
2.Locate four perimeter screws, two adjusting plates with set screws and two shims in the hardware packet.
3.Align shim under adjusting plate as shown in
Figure 6.
4.Slide one end of adjusting plate/shim in slot on mitered edge of top perimeter trim (see Figure 6).
5.Slide other end of adjusting plate/shim in slot on mitered edge of side perimeter trim (see Figure 6).
6.While firmly holding edges of perimeter trim together, tighten both set screws on the adjust- ing plate with slotted screwdriver.
7.Repeat steps 1 through 6 for other side.
8.Tighten trim hanging screws (#10 x 6.25 shoulder) into holes in cabinets. Place the assembled trim onto fireplace cabinet. Align hanging notches on trim with hanging screws on side of fireplace (see Figure 7). Push trim firmly into place, sliding hanging notches over hanging screws.
Set Screws
| Adjusting | Top | |
Side Trim | Plate | ||
Trim |
| Shim |
|
| Mitered | Slot |
Slot | Edge | |
|
|
Figure 6 - Assembling Perimeter Trim
Trim
Hanging
Screws
Hanging
Notches
on Trim
Assembled 
Trim
Figure 7 - Attaching Perimeter Trim to
Fireplace
INSTALLATION CLEARANCES
WARNING: Maintain the minimum clearances. If you can, provide greater clearances from floor, ceiling and adjoining wall.
Carefully follow the instructions below. This will ensure safe installation.
Minimum Clearances For Side Combustible
Material, Side Wall and Ceiling
A. Clearances from the side of the fireplace cabinet to any combustible material and wall should follow diagram in Figure 8.
Example: The face of a mantel, bookshelf, etc. is made of combustible material and protrudes 3 1/2" from the wall. This combus- tible material must be 4" from the side of the fireplace opening (see Figure 8).
B. Clearances from the top of the fireplace opening to the ceiling should not be less than 42".
Minimum Clearance to Combustible Materials
Top: 42", Left and Right Sides: 16"
Bottom and Rear: 0"
Example |
* |
*Minimum 16" from Side Wall
Figure 8 - Minimum Clearance for
Combustible to Wall
