INSTALLATION
Continued
LOCATING HEATER
This heater is designed to be mounted on a wall.
WARNING: Maintain the minimum clearances shown in Figure 4. If you can, provide greater clearances from floor, ceiling and joining wall.
WARNING: Never install the heater
•in a bathroom (10,000 Btu/hr only. 6,000 Btu/hr models are allowed in a bathroom. Check local codes.)
•in a recreational vehicle
•where curtains, furniture, clothing or other flammable objects are less than 36" (91.5 cm) from the front, top or sides of the heater
•as a fireplace insert
•in high traffic areas
•in windy or drafty areas
| CEILING | |
6" | 36" (91.5 cm) | |
Minimum | ||
(15.3 cm) | ||
Minimum |
| |
From |
| |
Sides Of |
| |
Heater |
| |
| Right | |
Left | Side | |
Side |
|
3" (7.7 cm)
Minimum To Top Surface
Of Carpeting, Tile Or Other
Combustible Material
Figure 4 - Mounting Clearances As
Viewed From Front of Heater
CAUTION: If you install the heater in a home garage
•heater pilot and burner must be at least 18" (45.7 cm) above floor
•locate heater where moving vehicle will not hit it
CAUTION: This heater cre- ates warm air currents. These currents move heat to wall sur- faces next to heater. Installing heater next to vinyl or cloth wall coverings or operating heater where impurities (such as, but not limited to, tobacco smoke, aromatic candles, cleaning flu- ids, oil or kerosene lamps, etc.) in the air exist, may discolor walls or cause odors.
IMPORTANT:
For convenience and efficiency, install heater
•where there is easy access for operation, inspec- tion and service
•in coldest part of room
THERMOSTAT SENSING BULB (Thermostat Models Only)
The thermostat sensing bulb is located inside the heater. Do not move this bulb during installation or operation of the heater.
INSTALLING HEATER TO WALL
Marking Screw Locations
1. Determine where you will locate heater.
WARNING: Maintain mini- mumclearancesshowninFigure 5, page 9. If you can, provide greater clearances from floor and joining wall.
2.Mark two mounting screw locations on wall (see Figure 5, page 9).
8 | www.desatech.com |