Product Features
Safety Pilot
This fireplace has a pilot with an Oxygen Deple- tion Sensing (ODS) safety shutoff system. The ODS/pilot is a required feature for
Piezo Ignition System
This fireplace has a piezo ignitor. This system requires no matches, batteries or other sources to light fireplace.
Thermostatic Heat Control
This fireplace has a thermostat sensing bulb and a control valve. The thermostat will automatically modulate the heat output to maintain a consistent room temperature. This results in greater fireplace comfort. This can also result in lower gas bills.
Unpacking
1.Remove fireplace from carton.
2.Remove all protective packaging applied to fireplace for shipment.
3.Make sure your fireplace includes one hard- ware packet.
4.Check fireplace for any shipping damage. If fireplace is damaged, promptly inform dealer where you bought fireplace.
Assembly
WARNING: Always have branch support and screen in place before operating fireplace. This prevents excessive temper- atures on fireplace surfaces.
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this fireplace may result in prop- erty damage or personal injury.
Assembling Fireplace
Tools Required:
• | Phillips screwdriver | • | slotted screwdriver |
• | 5/16" hex wrench | • | scissors |
Installing Log
1. Lift screen up and pull out to remove.
2. Cut two plastic straps to remove the log from the firebox cavity.
3. An optional blower is available for models CGCFTP and CGCFTN. See Accessories, page 27. Install optional blower now. Follow instal- lation instructions provided with blower.
4. Remove log packaging material and discard packaging. Gently place log set on burner support (see Figure 2). The log should fit flat against top of burner support and log locator tabs fit into the slots under the log. Do not allow log to contact flame. If flame contacts log, soot will be created.
5. Reattach screen by placing the notches in the screen frame over the shoulder screws and pushing down.
Burner Support with Log
Shoulder Locator Tabs
Log Screw
Branch
Support
Screen
