Installation
Continued
IMPORTANT: Make sure log does not cover any burner ports (see Figure 12).
Burner Ports | One Piece | |
Log Set | ||
|
Figure 12 - Installing One-Piece Log set
(Top View)
Installing Blower ACCESSORY GA3750
Tools required: Phillips screwdriver
NOTICE: Shut off gas heater during the following blower installation.
1.Remove top panel of stove by removing three screws from under top lip on each side of stove (see Figure 13).
2.Facing front of stove, carefully slide top panel forward until it is completely removed from stove (see Figure 13).
3.Disconnect power cord wires from blower motor (if connected) (see Figure 14).
4.Disconnect green ground wire from blower housing (if connected) by removing screw holding wire terminal (see Figure 14).
5.Install one plastic bushing provided in blower kit into the 1 1/2" hole in the left rear of firebox floor. Access hole through the rectangular opening in the rear panel (see Figure 15).
6.Remove the two blower mounting brackets from the rear panel by removing two screws each (see Figure 16, page 13).
7.Attach the two mounting brackets to blower housing using four screws provided in blower kit (2 for each bracket) (see Figure 16, page 13). Tighten screws securely. Place blower assembly temporarily on top of firebox.
8.Working from the rear of the stove, place entire power cord, including speed control housing, in lower control compartment.
9.Route ends of
10.Attach the terminal ends of the white and black power cord wires to the terminals on the blower motor (see Figure 14). Push firmly.
11.Attach the terminal end of the green power cord wire to the front tab of the blower housing using screw provided (see Figure 14).
Figure 13 - Removing Stove Top Panel
White | Black Powercord Wire |
Powercord | |
Wire |
|
Screw
Green Ground Wire
Figure 14 - Removing Wires from Blower
Bushing
Figure 15 - Installing Bushing
12 | www.desatech.com |
