Operation
WARNING: If you smell gas:
•Shut off gas to the appliance.
•Extinguish any open flames.
•If odor continues, immediately
call your gas supplier.
See safety warnings and pre- cautions starting on the front page of this manual for more information.
Before You Use Your Heater
1.Move heater to an open area.
2.Make sure tank valve is in its full off posi- tion (turn clockwise to stop).
3.Check tank valve features to ensure it has proper external mating threads. (Tank valve marked USE WITH TYPE 1.)
4.Never attempt to use any components that have been damaged or exposed to an accidental fire.
The connection provided with this heater incorporates two important features: Tem- perature Activated Shutoff and Excess Flow Control.
Match Hole 
Control
Valve
Button
Ignitor
Button
TO LIGHT
1.Open the main gas supply valve on pro- pane cylinder.
2.Open manual valve.
3.Press and hold silver control valve button for 3 seconds. While holding valve button, press red igniter button until the burner is lit (may require pushing more than once).
Continue to hold the heater control valve for 30 seconds then release.
4.TO MATCH LIGHT: Insert flame into match hole near burner. Press and hold control valve button until flame is lit. Continue to hold valve button for 30 seconds.
IMPORTANT: Smoke and odor (not a gas odor) emission may occur in the first 15 min- utes of use. Run heater at high setting for at least 15 minutes to eliminate this problem.
WARNING: If you smell gas while in use, immediately press and turn control knob to the OFF position to shutdown heater.
TO SHUT DOWN
1.Shut off main gas supply.
2.Close manual valve.
3.Wait 5 minutes before relighting heater.
Manual Valve
Figure 13 - Control Valve and Ignitor Buttons
www.desatech.com120948-01A
