Desa TD129 Installing Feet to Lower Poles, Base and Pole Assembly, Attaching Tank Straps

Assembly

1.Install threaded poles into triangular base as shown in Figure 1. Be sure to seat poles fully inside base.

2.Install lower legs by pressing push tab release and inserting into upper pole (see Figure 2). Be sure push button is locked in place.

3.Install 3 feet to lower legs as shown in Figure 3. Be sure to tighten wing bolt after installation.

4.Install tank straps to propane/LP gas cylinder as shown in Figure 4. Length of strap from tank flange to end of clip should be between 9" and 10" from tank flange.

This should maintain a 2" minimum clear- ance from bottom of propane/LP tank to ground.

Wing Nut On

Inside of Foot

Figure 3 - Installing Feet to Lower Poles

Figure 1 - Base and Pole Assembly

Push Tab

Release

Push Tab

Release in Hole

of Upper Pole

9"-10"

Figure 2 - Installing Lower Legs into

Upper Poles

Figure 4 - Attaching Tank Straps

120948-01Awww.desatech.com