Installation, Continued, Installing Heater Assembly

INSTALLATION

Installing Damper Clamp Accessory for Vented Operation Installing Heater Assembly

INSTALLATION

Continued

INSTALLING DAMPER CLAMP ACCESSORY FOR VENTED OPERATION

Note:When used as a vented decorative, appliance must be installed only in a solid-fuel burning ﬁreplace with a working ﬂue and con- structed of noncombustible material.

If your heater is a non-thermostatically-controlled model, you may use this heater as a vented product. There are three reasons for oper- ating your heater in the vented mode.

1.The ﬁreplace does not meet the clearance to combustibles requirements for vent-free operation.

2.State or local codes do not permit vent-free operation.

3.You prefer vented operation.

If reasons number 1 or 2 above apply to you, you must permanently open chimney ﬂue damper. You must install the damper clamp ac- cessory (to order, see Accessories, page 27). This will insure vented operation (see Figure 10). The damper clamp will keep damper open. Installation instructions are included with clamp accessory.

See chart below for minimum permanent ﬂue opening you must provide. Attach damper clamp so the minimum permanent ﬂue opening will be maintained at all times.

Area of Various Standard

Round Flues

Diameter (ins.)	Area (sq. ins.)

5"	20 sq. inches
6"	29 sq. inches
7"	39 sq. inches
8"	51 sq. inches

Chimney	Minimum Permanent
Height (ft.)	Flue Opening (sq. ins.)

6' to 15'	39 sq. inches
15' to 30'	29 sq. inches

Damper Clamp

INSTALLING HEATER ASSEMBLY

WARNING: If installing in a sunken ﬁreplace, special care is needed. You must raise the ﬁreplace ﬂoor to allow access to heater control panel. This will insure adequate air ﬂow and guard against sooting. Raise ﬁreplace ﬂoor with noncombustible material. Make sure material is secure.

CAUTION: Do not pick up heater assembly by logs. This could damage unit. Only handle assembly by grates.

IMPORTANT: Make sure the heater burners are level. If heater is not level, heater will not work properly.

Installation Items Needed

•control cover kit (provided with heater)

•approved ﬂexible gas hose and ﬁttings (provided with heater) (if allowed by local codes)

•sealant (resistant to propane/LP gas, not provided)

Note: Install optional GHRCTA Receiver and Hand-Held Remote Control Kit (see Accessories, page 27) before installing gas log heater (Remote-Ready Models Only). See installation instructions included with the kit.

1.Apply pipe joint sealant lightly to male threads of gas ﬁtting (not provided). Connect approved ﬂexible gas hose to inlet side of gas control (see Figure 11).

2.Position heater assembly in ﬁreplace.

3.Connect to gas supply. See Connecting To Gas Supply, (see Figure 12, page 11).

Gas Control

Damper Clamp

Damper

Flexible Gas Hose (if allowed by local codes)