12
INSTALLATION
Connecting To Gas Supply (Cont.) Checking Gas Connections
INSTALLATION
Continued
CSA
Approved Flexible Gas Hose (if allowed by local codes)
PROPANE/LP
-From External Regulator (11" W.C.**
to 14" W.C.
Pressure)
CHECKING GAS CONNECTIONS
2. | Cap off open end of gas pipe where equipment shutoff valve |
| was connected. |
3. | Pressurize supply piping system by either opening propane/LP |
| supply tank valve for propane/LP gas or opening main gas valve |
| located on or near gas meter for natural gas, or using compressed |
| air. |
4. | Check all joints of gas supply piping system. Apply noncorrosive |
| leak detection fluid to all joints. Bubbles forming show a leak. |
3" Minimum | NATURAL |
| - From Gas |
| Meter |
| (5" W.C.** |
| to 10.5" W.C. |
Gas Control | Pressure) |
| |
Pipe Cap | Tee |
Nipple | Joint |
Sediment Trap
Figure 13 - Gas Connection
*Purchase the optional CSA
**Minimum inlet pressure for purpose of input adjustment.
WARNING: Test all gas piping and connections for leaks after installing or servicing. Correct all leaks at once.
WARNING: Never use an open flame to check for a leak. Apply a noncorrosive leak detection fluid to all joints. Bubbles forming show a leak. Correct all leaks at once.
CAUTION: Make sure external regulator has been installed between propane/LP supply and heater. See guidelines under Connecting to Gas Supply, page 11.
Pressure Testing gas Supply Piping system
Test Pressures In Excess Of 1/2 PSIG (3.5 kPa)
1.Disconnect appliance with its appliance main gas valve (control valve) and equipment shutoff valve from gas supply piping system. Pressures in excess of 1/2 psig will damage heater regulator.
5. | Correct all leaks at once. |
6. | Reconnect heater and equipment shutoff valve to gas supply. |
| Check reconnected fittings for leaks. |
Test Pressures Equal To or Less Than 1/2 PSIG (3.5 kPa)
1.Close equipment shutoff valve (see Figure 14).
2.Pressurize supply piping system by either opening propane/LP supply tank valve for propane/LP gas or opening main gas valve located on or near gas meter for natural gas, or using compressed air.
3.Check all joints from gas meter to equipment shutoff valve for natural gas or propane/LP supply to equipment shutoff valve for propane/LP (see Figure 15, page 13). Apply noncorrosive leak detection fluid to all joints. Bubbles forming show a leak.
4.Correct all leaks at once.
Pressure Testing Heater Gas Connections
1.Open equipment shutoff valve (see Figure 14).
2.Open main gas valve located on or near gas meter for natural gas or open propane/LP supply tank valve.
3.Make sure control knob of heater is in the OFF position.
4.Check all joints from equipment shutoff valve to gas control (see Figures 15 and 16 page 13). Apply noncorrosive leak detection fluid to all joints. Bubbles forming show a leak.
5.Correct all leaks at once.
6.Light heater (see Operating Heater, pages 14 through 16). Check all other internal joints for leaks.
7.Turn off heater.
ON
EquipmentPOSITION
(OPEN)
Shutoff
Valve
OFF
POSITION
(CLOSE)
Figure 14 - Equipment Shutoff Valve
For more information, visit www.desatech.com
