FIREPLACE INSTALLATION
Continued
FIREPLACE INSTALLATION | 23 |
Installing Logs, Lava Rock and Glowing Embers | |
OPERATING FIREPLACE |
|
For Your Safety Read Before Lighting |
|
|
|
INSTALLING LOGS, LAVA ROCK AND GLOWING EMBERS
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with fireplace.
Open louvers, remove screen, unlock door latches, and open glass door. See Removing/Replacing Glass Door, steps 1 and 2 on page 22. Install logs according to instructions for fireplace model numbers.
5
6 
7
1.Place log #1 (left base log) onto pin on left side of burner as shown in Figure 44.
2.Place log #2 (right base log) onto pin on right side of burner as shown in Figure 44.
3.Place logs #3 (left front log) and log #4 (right front log) onto pins as shown in Figure 45.
4.Place log #5 (right rear log) onto pins on right rear of burner (see Figure 46). Rest log #6 (middle crossover log) on top of log number 2 as shown in Figure 46.
5.Place back end of log #7 (left rear log) onto pin on left rear burner and rest front onto log #1 as shown in Figure 47.
6.Rest log #8 (left crossover log) onto log #3 and rest log #9 (right crossover log) onto logs #4 and #5 as shown in Figure 48.
7.Pull ember material apart into pieces no larger than a dime. Place these pieces loosely and sparingly directly onto the exposed front section of the burner (see Figure 49). This will create the glowing ember appearance as the flame touches the ember material. Do not block air slots by using too much ember material in one area. It is not necessary to use all of the ember material provided.
NOTICE: Do not put lava rock on burner or under burner. Placing lava rock on burner will cause perfor- mance problems.
8.Close glass door, lock door latches, replace screen, and close louvers (see Removing/Replacing Glass Door, steps 5 through 7 on page 22).
WARNING: The glass door must be securely in place before running this fireplace. Do not run this fireplace if glass is missing or broken.
2 | 3 |
1 | 4 |
|
Figure 44 | - Installing Logs | Figure 45 - Installing Logs |
No. 1 and No. 2 | No. 3 and No. 4 | |
Figure 46 - Installing Logs | Figure 47 - Installing Log No. 7 |
No. 5 and No. 6 |
|
9
8
Figure 48 - Installing Logs No. 8 and No. 9
Ember Material
Figure 49 - Placing Ember Material on Burner
OPERATING FIREPLACE
FOR YOUR SAFETY READ
BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop- erty damage, personal injury or loss of life.
A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
For more
visit www.
.com
