Cisco Systems OL-31454-01 manual Installing the Switch Module in the CGR 2010 Router

Chapter 5 Installing and Upgrading Internal Modules

Installing Grid Router WAN Interface Cards

Step 4 Grasp the handles and carefully slide the module into the card guide, then push with both hands until the module is flush against the router chassis (see Figure 5-11).

Figure 5-11 Installing the Switch Module in the CGR 2010 Router

237927

Step 5 Tighten the screws in the order specified here:

a. First tighten the lower flathead screw to the bottom center hole. b. Then tighten the second panhead screw to the top center hole.

Step 6 Tighten the three captive screws on the front of the module in this order:

a.First tighten the captive screw on the lower left of the module.

b.Then tighten the single captive screw on the right side of the module.

c.Finally, tighten the captive screw on the upper left of the module.

The double-wide GRWIC is now successfully installed in the router (see Figure 5-12).

	Cisco 2010 Connected Grid Router Hardware Installation Guide
5-12	OL-31454-01