Cisco Systems OL-31454-01 manual Installing a Compact Flash Memory Card

Chapter 5 Installing and Upgrading Internal Modules

Removing and Installing Compact Flash Memory Cards

Figure 5-3 Compact Flash Memory Card Slot in Cisco CGR 2010

PSU OK PWR-150W-HV

CF1

				PSU2
DO
NOT				CF0
REMOVE		DURING
NETWORK
	OPERATION
	DO
	NOT
		REMOVE		DURING
	NETWORK
			OPERATION

1

2

PS

Type

Lo V DC

Hi V DC

or

V AC

Cisco Connected

1

Ejector button

2

Compact flash slot

Step 3 Press the ejector button again (see Figure 5-3). This ejects the compact flash memory card part-way out of its slot.

Step 4 Pull the compact flash memory card out of its slot.

Step 5 Push the ejector button in until the button is flush with the bezel.

Caution To prevent damage to the ejector mechanism, the ejector button must remain pressed in all the way (flush against the bezel) when not being used to eject a compact flash memory card.

Installing a Compact Flash Memory Card

To install a compact flash memory card, perform the following steps:

Step 1 Make sure that the ejector button is fully seated until it is flush with the bezel.

Note If the ejector button is projecting out from the panel, push it in until it is flush with the bezel.

Step 2 Insert the compact flash memory card into the slot until it is fully seated. The ejector button remains flush with the panel.

Cisco 2010 Connected Grid Router Hardware Installation Guide

OL-31454-01 5-5