![](/images/new-backgrounds/1196782/196782169x1.webp)
Chapter 4 Configuring the Router
Performing the Initial Configuration on the Router
5.end
DETAILED STEPS
| Command or Action | Purpose |
Step 1 |
|
|
enable | Enables privileged EXEC mode. | |
|
| • Enter your password if prompted. |
| Example: |
|
| Router> enable |
|
Step 2 |
|
|
configure terminal | Enters global configuration mode. | |
| Example: |
|
| Router# configure terminal |
|
Step 3 |
|
|
hostname name | Specifies or modifies the hostname for the network server. | |
| Example: |
|
| Router(config)# hostname myrouter |
|
Step 4 |
|
|
Verify that the router prompt displays your new | — | |
| hostname. |
|
| Example: |
|
| myrouter(config)# |
|
Step 5 |
|
|
end | (Optional) Returns to privileged EXEC mode. | |
| Example: |
|
| myrouter# end |
|
|
|
|
Configuring the Enable and Enable Secret Passwords
To provide an additional layer of security, particularly for passwords that cross the network or are stored on a TFTP server, use either the enable password command or the enable secret command. Both commands accomplish the same
We recommend that you use the enable secret command because it uses an improved encryption algorithm. Use the enable password command only if you boot an older version of the Cisco IOS software or if you boot older boot ROMs that do not recognize the enable secret command.
For more information, see the “Configuring Passwords and Privileges” chapter in Cisco IOS Security Configuration Guide. Also see Cisco IOS Password Encryption Facts and Improving Security on Cisco Routers.
Restrictions
If you configure the enable secret command, it takes precedence over the enable password command; the two commands cannot be in effect simultaneously.
Cisco 2010 Connected Grid Router Hardware Installation Guide
|
| ||
|
|