Desa VC42N, CGCDV42NR, VC42P, CGCDV42PR Removing/Replacing Glass Door, Held Remote Control Unit

Models: (V)VC42P, CGCDV42PR VC42N, CGCDV42NR, VC42P, CGCDV42PR

1 44
Download 44 pages 41.87 Kb
Page 25
Image 25
Installing 9-Volt Alkaline Battery in Hand-

Fireplace

Installation

Continued

Installing 9-Volt Alkaline Battery in Hand-

Held Remote Control Unit

1. Remove battery cover on back of remote control unit.

2. Attach terminal wires to a 9-volt alkaline battery (not included). Place battery into the battery housing.

3. Replace battery cover onto remote control unit.

Removing Louver Panels

Remove the top and bottom louver panels by si- multaneously pulling both top end spring latches towards the center of the appliance until they are disengaged from the locating holes (see Figure 40). Repeat for bottom spring latches and pull the lou- vers outward. To install or replace items removed, simply reverse the procedures above.

Battery Cover

Remote Control Unit

 

Louver Panel

Held Remote Control UnitRemoving Louver Panels Spring Latch

Terminal

 

Wires

 

9-Volt

Battery

Housing

Battery

 

Figure 39 - Installing Battery in Hand-

Held Remote Control Unit

Removing/Replacing Glass

Door

Removing/Replacing Glass CAUTION: Do not operate this fireplace with a broken glass door panel or without the glass door panel securely in place. For replacement part informa- tion see Replacement Parts, page 37.

Removing Glass Door CAUTION: Wear gloves and safety glasses while handling or removing broken glass. Do not remove if glass is hot. Keep children and pets away from glass.

Manual background WARNING: If fireplace has been running, turn off and un- plug fireplace. Let cool before re- moving glass door or louvers.

Figure 40 - Removing Louver Panel

Removing Glass Door

If replacement of glass is necessary, the entire assembly, glass and frame, must be replaced. If glass is broken, wear gloves and tape the remaining fragments onto the frame.

1.Remove screen assembly by pushing the rod either left or right and then down and forward to remove screen/rod assembly from the fire- box. Set assembly aside.

2.Lift up on latches to unlock. There are two on top of firebox and two below firebox that hold glass door in place (see Figure 41).

3.While holding glass door to prevent it from falling and causing injury, remove the five screws from the hinge located on the left side of door frame assembly (see Figure 41).

Unlock Manual backgroundManual background Lock

Latch

Screw

Hinge

Glass Frame

Assembly

Figure 41 - Removing/Replacing Glass

Door

116236-01E

www.desatech.com

25

Page 25
Image 25
Desa VC42N, CGCDV42NR, VC42P, CGCDV42PR Removing/Replacing Glass Door, Installing 9-VoltAlkaline Battery in Hand