Glass Door Installation
Continued
Installing glass doors
Spring clips have been installed. Some adjust- ments may be needed. Install doors using the following steps:
1.With bifold doors completely folded, insert bottom pivot pin into pivot hole located near bottom corner of front face opening and swing door to vertical position making sure top pins slide into door track. Door is installed when top door pin snaps into spring clip.
2.Repeat step 1 for remaining door.
If you find the doors do not close properly or do not appear level or straight, proceed with section on door adjustment,
Fold Door | Spring |
and Slide | Clip |
Top Pins | Insert Pin |
Into Track | |
| into Spring |
| Clip |
Insert
Bottom
Pivot Pin
into Hole
Pivot
Hole
Figure 29 - Installing Bi-Fold Doors
Door Adjustment
Remove doors and slightly loosen lower pivot clips and upper spring clips. Replace doors and fully close them. Use 1/8" shims (any material) to level doors. Once proper setting is achieved, carefully open doors enough so that you can access spring clips with a phillips screwdriver. Tighten screws. See Figure 30.
Figure 30 - Adjusting Bi-Fold Doors
30 | www.desatech.com |
