INSTALLING HEATER
Continued
Installation must include a manual shutoff valve, ground joint union, plugged 1/8" NPT tap and a sediment trap. Locate NPT tap within reach for test gauge hook up. NPT tap must be upstream from heater (see Figure 7).
Apply pipe joint sealant lightly to male threads. This will prevent excess sealant from going into pipe. Excess sealant in pipe could result in clogged heater valves.
CAUTION
WARNING ICON | G 001 |
Use pipe joint sealant that is resistant to liquid petroleum (LP) gas.
Install sediment trap in supply line as shown in Figure 7. Locate sediment trap where it is within reach for cleaning. Locate sediment trap where trapped matter is not likely to freeze. A sediment trap traps moisture and contaminants. This keeps them from going into heater controls. If sediment trap is not installed or is installed wrong, heater may not run properly.
IMPORTANT: Use two pipe wrenches when connecting gas piping to gas control valve of heater. This will prevent turning or damaging control valve.
Control
Valve
Ground
Joint
Union
|
| Reducer |
|
|
| Bushing to |
|
Test |
| 1/8" NPT |
|
| 1/8" NPT |
| |
Gauge |
|
| |
| Plug Tap | ||
Connection* | |||
|
| Tee Joint | |
|
| Sediment | |
|
| Trap | |
Manual
Shutoff
Valve *
Tee Joint
Pipe
Nipple
Cap
Acceptable construction of inlet gas line
From External Regulator (11" W.C. Min** to 14" W.C. Max)
Preferred construction of inlet gas line
From External Regulator (11" W.C. Min** to 14" W.C. Max)
12
Figure 7 - Gas Connection
*An A.G.A.
**For purposes of input adjustment.
100793
