INSTALLATION
Continued
INSTALLING LOGS
CAUTION: After installa- tion and periodically thereafter, check to ensure that no flame comes in contact with any log. With the heater set to HI, check to see if flames contact any log. If so, reposition logs according to the log installation instructions in this manual. Flames contact- ing logs will create soot.
WARNING: Failure to posi- tion the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
Dual Burner Biltmore Split Oak Models CCL3018PTA/NTA, CCL3924PTA/NTA, CCL3930PTB/NTB
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
1.Place the front log (#1) on the grate fingers. Make sure the front log rests firmly between the grate fingers and the grate base (see Figure 19).
2.Place the base of the middle log (#2) in the
3.Locate pins on the bottom of back log (#3). Slide these pins into the holes in the grate base behind the burner (see Figure 21).
4.Locate holes on the bottom of crossover log (#4). Slide front hole onto the left pin (CCL3924PTA/NTA or CCL3930PTB/ NTB) or middle pin (CCL3018PA/NA or CCL3018PTA/NTA) on the middle log (#2) and the pin on the back log (#3). See Figure 22, page 17, for placement.
Front
Log (#1)
Grate
Fingers
Grate
Base
Figure 19 - Installing Front Log #1 (CCL3930PTB/NTB Shown)
Middle
Log (#2)
Burner
Tab | |
|
Figure 20 - Installing Middle Log #2
(CCL3930PTB/NTB Shown)
Pins
Rear
Log (#3)
Hole in
Grate Base
Burner
Figure 21 - Installing Rear Log #3
(CCL3930PTB/NTB Shown)
16 | www.desatech.com |