INSTALLATION
Continued
NOTICE: If your installation does not meet the minimum clear- ances shown, you must do one of the following:
•operate the logs only with the flue damper open
•raise the mantel to an accept- able height
•remove the mantel
Hearth
Combustible Material
5"
Min.
Figure 9 - Minimum Fireplace Clearances
Above Combustible Flooring
INSTALLING DAMPER CLAMP ACCESSORY FOR VENTED OPERATION
12"
10"
8"
6"
2 1/2"
Minimum
Noncombustible
Material8"
Min.
Mantel Shelf
Underside
of Mantel
Shelf
All minimum distances are in inches
|
|
|
| Log Set | |
12" | 15" | 18" | 20" |
| All |
| Models | ||||
|
|
|
|
|
Note: When used as a vented heater, appliance must be installed only in a
If your heater is a
1. | The fireplace does not meet the clearance |
Hood
(GA6050, GA6052 and GA6053)
Distances to Underside of Mantel
Top of
Fireplace
Opening
| to combustibles requirements for |
| operation. |
2. | State or local codes do not permit |
| operation. |
3. | You prefer vented operation. |
Figure 7 - Minimum Mantel Clearances
When Using Hood
FLOOR CLEARANCES
A.If installing appliance on the floor level, you must maintain the minimum distance of 14" to combustibles (see Figure 8).
B.If combustible materials are less than 14" to the fireplace, you must install appliance at least 5" above the combustible flooring (see Figure 9).
If reasons number 1 or 2 above apply to you, you must permanently open chimney flue damper. You must install the damper clamp accessory (to order, see Accessories, page 38). This will insure vented operation (see Figure 10). The damper clamp will keep damper open. Installation instructions are included with clamp accessory.
Damper
Clamp
Damper
Damper
Clamp
|
| Damper | Damper |
| Combustible |
|
|
14" | Material |
|
|
|
|
| |
Min. |
|
|
|
| Noncombustible | Masonry | Manufactured |
| Fireplace | Fireplace | |
| Material | ||
|
|
| |
Figure 8 - Minimum Fireplace Clearances | Figure 10 - Attaching Damper Clamp | ||
if Installed at Floor Level |
|
|
www.desatech.com | 11 |