OPERATING HEATER
Continued
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: Keep flue open when operating unit.
WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result causing property damage, per- sonal injury or loss of life.
A.This appliance has a pilot which must be lighted with a piezo ignitor. When lightning the pilot, follow these instructions exactly.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighborʼs phone. Follow the gas supplierʼs instructions.
•If you cannot reach your gas supplier, call the fire department.
C.Use only your hand to push in or turn gas control knob. Never use tools. If the knob will not push in or turn by hand, do not try to repair it, call a qualified technician. Force or attempted repair may result in a fire.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
LIGHTING
INSTRUCTIONS
NOTICE: During initial operation the appliance will emit a slight odor for an hour or two. This is due to the
1.STOP! Read the safety information, col- umn 1.
2.Make sure equipment shutoff valve is fully open.
3.Set switch in the Local position.
4.Wait five (5) minutes to clear out any gas. If you then smell gas STOP! Follow the safety information above. If you don't smell gas, go on to the next step.
5.Turn PilotStat knob to PILOT. Push in on PilotStat knob and press Piezo button until the pilot is lit.
6.Continue to hold PilotStat knob in until LED blinks (one brief blink every two seconds) then release knob. Note: You will need to hold the knob in for about one minute.
7.Turn PilotStat knob to ON See Figure 12, page 9.
WARNING: Moving the Lo- cal/Remote switch can cause the main burner to come on immediately. Stand away from the main burner when moving the local/remote switch to avoid possible injury.
USING TRANSMITTER/
REMOTE
1.Move switch to REMOTE position (see Figure 12, page 9).
2. Press FAN | or FLAME | key within |
30 seconds.
3.Make sure LED turns on for one second.
10 | www.desatech.com |
