Design Dynamics HCM-18-RFP, HKE-24-RFP, HKE-24-RFN Operating Heater, Inspecting Burners, Continued

OPERATING HEATER

Continued

4.	Press MODE	button until mode
	shows in display window of transmitter/
	remote. Press up or down key to change
	set temperature.
5.	To set delay timer, press TIMER		button

followed by either the up or down key.

6.To change the flame height, press the

MODE button until mode is ON. Press

the FLAME	button and press the up or
down arrow key.

7.To change between Fahrenheit and Celsius, press the up and down arrow keys at the same time and hold for at least three seconds.

TO TURN OFF GAS

TO APPLIANCE

Shut Off Main Burner Using Remote

Press MODE button until mode is OFF. Pilot stays lit.

Shut Off Main Burner Without Remote

Turn PilotStat knob to PILOT. Pilot stays lit.

Shut Off Main Burner and Pilot

Turn PilotStat knob to OFF.

CAUTION: During normal shutdown of this unit, a flash may be observed due to the na- ture of the burner components. Remain clear of the unit during the shutdown process.

INSPECTING BURNERS

Check pilot flame pattern and burner flame pat- terns often.

Flames from the pilot should always be present when the appliance is in operation (see Figure 13).

The flame should look similar to those in Figure 14. The flames should look random in appearance with the ember bed glowing red-orange in color.

Figure 13 - Correct Pilot Flame Pattern

Hardwood Original Log Set

California Maple Log Set

Kentucky Elm Log Set

Figure 14 - Log Sets with Flame Patterns

115481-01B www.desatech.com 11