Using a Bluetooth wireless headset | Getting Started |
|
|
Tip: Note: If your headset is not displayed in the Found: box, select your headset from the list, as follows:
a.Press the Right navigation key one or more times to highlight the Found: box. Press the Enter key to start the edit mode.
b.Press the Down navigation key to open the Found: list. Press the Up/ Down navigation keys to scroll and highlight your headset.
c.Press the Enter key to select the headset and close the list. Press the Enter key to exit edit mode.
6.Press the Right navigation key to highlight the Pair button (next to the Pair Device item) and press the Enter key.
At the prompt ”Enter PIN#”, enter the PIN using the phone dialpad and press the Enter key. If pairing is successful, the message "Pair completed" displays.
Tip: Check your headset documentation to find its PIN (sometimes called a passkey). Typically this value is 0000.
If the headset is not successfully paired with your phone, an error message appears at the bottom of the screen. If an error message appears:
• Confirm that the wireless headset is still in search/pair mode. If the headset timed out and exited search/pairing mode, put the headset in pairing mode, as discussed in step 3, and repeat step 6.
• Check that you are using the correct PIN. Repeat step 6.
Dual Pairing headsets
Take special care when using a "dual pairing" type of Bluetooth wireless headset, which can be paired to its base as well as to the IP Phone 1140. If it is paired to both, the IP Phone 1140 is the second device, and the following applies:
Press the headset "telephone" key:
•
•
If a single tone sounds, the headset is connected to the base.
If a double beep sounds, the headset is connected to the IP Phone 1140.
If the base is powered off, the headset is only paired to the IP Phone 1140 and pressing the "telephone" key connects you to the IP Phone 1140.
If more than one wireless headset is paired, the first headset paired is automatically made the active device.
To make a different headset active, do the following.
1.Press the Right navigation key to highlight the Set button (next to the Set Active Device item).
2.Press the Enter soft key.
Copyright © 2007 Cypress Communications, Inc. All Rights Reserved. | 15 |
