DeWalt AV200 manual Multicast Configuration, Adapter Configuration

Adapter Configuration

Note: It is strongly advised to turn on the notching function.

Power Control is an automatic transmission power control which prevents different networks from overpowering each other.

Power Control is turned on only when other networks are detected in the channel. If the transmission strength reaches the isolation point between networks, the transmission power is limited from overpowering the other network. If the isolation point is not reached, the adapters continue transmitting as normal.

3.4.5Multicast Configuration

In order to optimize multicast traffic (video streams, etc.) between AV200 Powerline adapters, you can specify which adapters should receive the video. Other adapters

will then not be able to receive the multicast communication, and therefore the 23 bandwidth will be used only for transmission to the intended recipients, making your broadcast, and your entire network, more efficient.

This form shows the list of multicast bindings, where the IP addresses of adapters are assigned to a unicast (video source) MAC address. This list can be saved to memory on the wall mount adapter (Save in NVRAM). Bindings can be removed by checking their “Remove” checkboxes and clicking “OK”. Add a new binding to the list by entering the multicast IP address in decimal format (ddd.ddd.ddd.ddd), and the unicast (source) MAC address, in hexadecimal format (XXXXXXXXXXXX), in the appropriate fields and clicking “OK.”

The new IGMP Aware Multicast Syndication feature can be enabled via this form. This feature is only available on private networks (those with a valid Network Identifier) and End Points (EP).

Corinex AV200 Powerline Ethernet Wall Mount