Allied Telesis fast ethernet 10/100 hubs Changing Network Configuration, Parameters Description

AT-FH812u and AT-FH824u User’s Guide

Changing the

Network

Configuration

Use the Network Configuration screen to configure the hub's Internet Protocol (IP) parameters, set the bootup option, and define the maximum number of Telnet sessions allowed. Table 3 defines the screen’s parameters listed in Figure 4.

------------------------------------------------------------------

		System Configuration
		Current Used	New Setting
	----------------------------------------------------
	IP Address	: 10.1.113.115	10.1.113.115
	Subnet Mask	: 255.255.0.0	255.255.0.0
	Gateway IP	: 0.0.0.0	0.0.0.0
	SLIP IP	: 0.0.0.0	0.0.0.0
	Bootup IP	: 0.0.0.0	0.0.0.0
MAX # of allowed Telnet sessions (0 - 2) : 2
<APPLY>	<OK>	<CANCEL>

The new IP address. <Ctrl-F> forward a char, <Ctrl-B> backward a char.

-----------------------------------------------------------

	Figure 4 System Configuration Example
	Table 3 Network Configuration Parameters
Parameters	Description
IP Address	IP address of the agent you are managing. The Agent Module supports SNMP over UDP/IP transport
	protocol. In this environment, all systems on the Internet, such as network interconnection devices
	and any PC accessing the Agent Module, are assigned an IP address. Valid IP addresses consist of
	four numbers, from 0 to 255, separated by periods. Anything outside of this format will not be
	accepted by the configuration program. (The default address is 0.0.0.0.)
Subnet Mask	Subnet mask of the agent you have selected. This mask identifies the host address bits used for
	routing to specific submits. (The default subnet mask is 0.0.0.0.)
Default Gateway	Gateway used to pass trap messages from the hub's agent to the management station. Note that the
	gateway must be defined if the management station is located in a different IP segment. (The default
	gateway is 0.0.0.0.)
SLIP IP	IP address used to access the configuration program via an out-of-band SLIP connection to the serial
	port on the Agent Module.
Bootup IP	The default IP address assigned to this agent. This address is used only until you assign a new
	address to the agent, or after downloading new firmware to the Agent Module.
Max # of	The maximum number of Telnet sessions allowed to simultaneously access the Agent Module.
allowed

9