Hub Configuration
Use the Hub Configuration screen to configure any hub in the stack. This menu is used to configure the selected hub, as well as the Agent Module. Use the menu in Figure 8 to view a basic description of all the hubs in the stack, including hardware and firmware version numbers, or to open a more detailed configuration screen for a specific hub. The information provided in Figure 8 is described in Table 7 and Table 8, and in Figure 9:
Hub Selection Menu
|
| Hub Configuration: Hub Selection Menu |
| ||||
Hub H/W | EPROM | FLASH | PORT | SNMP | Switch | Detailed | |
ID | Version F/W Ver | F/W Ver | Number Agent | Module | Screen | ||
1. 1 | 0.11 | 0.03 | 24 | Master | None <GO> | |
|
|
|
| <PREV_PANEL> |
|
|
|
| Go to hub configuration detailed screen. | ||||
| Use TAB or Cursor keys to move, <Enter> to confirm. | |||||
|
|
| Figure 8 Hub Selection Menu |
|
| |
|
| Table 7 Hub Selection Parameters |
| |||
|
|
|
|
|
| |
Parameters |
| Description |
|
|
| |
|
|
| ||||
|
|
| ||||
Hub ID |
| Hub identifier in stack. (Up to 6 hubs may be connected via the | ||||
|
| stack cable.) |
|
|
| |
|
|
| ||||
H/W version |
| Hardware version number of the repeater board. | ||||
|
|
| ||||
EPROM F/W ver |
| Version number of the repeater firmware in permanent | ||||
|
| memory. |
|
|
| |
|
|
| ||||
Flash F/W ver |
| Version number of the repeater firmware in temporary memory. | ||||
|
|
| ||||
Port Number |
| Indicates whether this device has 12 or 24 repeater ports. | ||||
|
|
| ||||
SNMP Agent |
| Indicates whether an Agent Module is installed in this hub. | ||||
|
|
| ||||
Switch Module |
| Indicates whether an Internal Switch Module is installed in this | ||||
|
| hub. |
|
|
|
|
|
|
|
|
|
|
|
13
