Configuring Port Parameters
Select Administrative Status Control from the Port Configuration screen to configure any port on the hub. The following menu shows the configuration options. In addition to the functional parameters listed in Figure 10, note that you can also enable/disable any port. Table 9 lists and defines the Port Administration Status control parameters.
| |||||
|
| Port Administration Status Control (1 - 12) | |||
Hub ID : 1 |
|
|
|
| |
Port | Admin State Link State | Partition | Mode | Speed | |
1. | Enabled | Connected | Auto | 100M | |
2. | Enabled | Connected | Auto | 100M | |
3. | Enabled | Connected | Auto | 100M | |
4. | Enabled | Connected | Auto | 100M | |
5. | Enabled | Connected | Auto | 100M | |
6. | Enabled | Connected | Auto | 10M | |
7. | Enabled | Connected | Auto | 100M | |
8. | Enabled | Connected | Auto | 10M | |
9. | Enabled | Connected | Auto | 100M | |
10. | Enabled | Connected | Auto | 100M | |
11. | Enabled | Auto | 10M | ||
12. | Enabled | Connected | Auto | 100M | |
<APPLY> | <OK> | <CANCEL> | <PORT_13_24> |
| The administrative status of port. | ||
Use TAB or Cursor keys to move, <Space> to select.
Figure 10 Port Administration Status Control
Note
If a port is disabled by an intrusion action, you must disable it manually in the Administration Status menu, then re-enable it to restore the connection. See Configuring Port Security on page 19.
16
