| Table 8 Hub Configuration Parameters |
|
|
Parameters | Description |
|
|
|
|
Hub |
|
|
|
Hub ID | Hub identifier in stack. |
|
|
Serial No | Serial number of this hub. |
|
|
10M Backplane | Attaches/isolates hub's 10 Mbps repeater bus from the stack's |
| data channel. |
|
|
100M Backplane | Attaches/isolates hub's 100 Mbps repeater bus from the |
| stack's data channel. |
|
|
H/W Ver | Hardware version number of the repeater board. |
|
|
# of Ports | Indicates whether this device has 12 or 24 repeater ports. |
|
|
SNMP Agent |
|
|
|
Baudrate | Rate at which data is sent between the Agent Module's serial |
| port and the connected device. Supported baud rates are 9600, |
| 19200 and 38400 bps. |
|
|
Bootup Option | Specifies whether or not IP functionality is enabled (via manual |
| configuration), set by Boot Protocol (BootP), or disabled. |
| Options include: |
| IP Enabled - IP functionality is enabled based on the |
| default or configured settings. (The default is IP Enabled.) |
| BootP Get IP - IP is enabled but will not function until a |
| BootP reply has been received. BootP requests will be |
| periodically broadcast by the hub in an effort to learn its IP |
| address. |
|
|
MAC Address | Physical address of the Agent Module. |
|
|
H/W Version | Hardware version number of the Agent Module. |
|
|
POST Ver | Version number of the Agent Module's |
|
|
System Ver | System firmware version. |
|
|
Switch Module |
|
|
|
Type | Indicates if an internal switch or media extension module is |
| installed. |
|
|
15
