Chapter 5 Configuring the MGX
Booting the
Router(config)#interface fastEthernet 1/1
Step 3 You can assign an IP address and subnet mask to the interface with the ip address configuration subcommand, as in the following example.
Router(config-if)#ip address 172.29.54.166 255.255.255.0
Step 4 Enter any additional configuration subcommands required to enable routing protocols and set the interface characteristics.
Step 5 Start up the Ethernet interface by entering the following command:
Step 6 Configure additional interfaces as required.
Step 7 When you have included all of the configuration subcommands to complete the configuration, type end or press
Step 8 Save your configuration changes as follows:
Router#copy run start
Selecting
Step 1 Enter the
Router>enable
Password:
Router#config t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#interface fastethernet 1/1
Step 2 Enter the show interfaces fastethernet command to verify that the 2/1 Fast Ethernet interface is now configured for
Router#show interface fastethernet 1/1
FastEthernet1/1 is administratively down, line protocol is down Hardware is DEC21140, address is 0050.54ad.7c80 (bia 0050.54ad.7c80) MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 252/255, txload 1/255, rxload 1/255 Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Last input never, output 1d00h, output hang never Last clearing of "show interface" counters never Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops 5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 | packets input, 0 bytes |
|
| ||
| Received 0 broadcasts, 0 runts, 0 giants, 0 throttles |
|
| ||
0 | input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored |
|
| ||
0 | watchdog |
|
| ||
|
| Cisco MGX Route Processor Module |
|
|
|
|
|
|
|
| |
| Release 2.1, Part Number |
| |||
|
| ||||
