Cisco Systems 78-12510-02 manual Upgrading Non-redundant RPM-PR Cards

Chapter 5 Configuring the MGX RPM-PR

Establishing 1:N Redundancy Between Two or More RPM-PR Cards

Step 6 Continue this procedure from Step 2 for all remaining cards.

Upgrading Non-redundant RPM-PR Cards

The following procedure describes how to upgrade non-redundant RPM-PR cards.

Step 1 Configure the RPM-PR card to store its configuration on the PXM hard disk by entering the boot config e:auto_config_<slot#> command or by saving it in NVRAM by entering the WR MEM command.

Step 2 Modify the running configuration to boot from the new upgrade software by entering the boot system command.

Step 3 Enter WR MEM to save the configuration.

Step 4 Reset the RPM-PR card by entering the reset command from the PXM or the reload command from the RPM-PR.

	Cisco MGX Route Processor Module (RPM-PR) Installation and Configuration Guide
5-20	Release 2.1, Part Number 78-12510-02 Rev. C1, August 31, 2004