English
INSTALLATION
Pressure Washer Assembly (Fig. 1)
1.Place handle assembly (O) onto frame, depress the snap buttons, and slide the handle assembly onto the frame (F) until snap buttons are secured
in place. | O |
|
Caution: Risk of personal injury. Avoid placing F hands between handle and frame when assembling 
to prevent pinching.
NOTE: The high pressure pump is maintenance free and requires no oil, if there is a problem with the pump contact a DeWALT factory service center, a DeWALT authorized service center or other qualified service personnel.
Warning: Risk of bursting. Use a tire pressure gauge to check the tires pressure before each use and while inflating tires; see the tire side- wall for the correct tire pressure.
NOTE: Air tanks, compressors and similar equipment used to inflate tires can fill small tires similar to these very rapidly. Adjust pressure regulator on air supply to no more than the rating of the tire pressure.
2.Attach
3.Connect wand (E) to spray gun. Make sure connection is secure.
p |
e |
Add air in small increments and frequently use the tire gauge to prevent over inflation.
OPERATION
Pressure Adjustments
The pressure setting is preset at the factory to achieve optimum pres sure and cleaning. To lower the pressure, follow these instructions.
4. | Thread the side handle (D) into spray |
|
| gun extension and tighten to desired |
|
| position. |
|
5. | Place the nozzle holder (B) onto the |
|
| panel assembly (A) and push each | D |
| nozzle holder into place. | |
|
|
6.Remove the five colored
insert | them | into |
| |
correct grommet on | B | |||
the nozzle holder. | ||||
| ||||
Nozzles | are | color | A | |
coded | to | match | ||
colored | nozzles on |
| ||
panel assembly.
1.Back away from the surface to be cleaned. The further away you are, the less the pressure will be on the surface to be cleaned.
2.Change to the 40˚ nozzle (white). This nozzle delivers a less powerful stream of water and a wider spray pattern. Refer to Spray Wand Nozzles.
Caution: DO NOT attempt to increase pump pressure. A higher pressure setting than the factory set pressure may damage pump.
3.Reduce the speed of the gasoline engine (RPM). Slow the engine down and the water pressure will go down with it.
Spray Wand Nozzles (Fig. 1)
The nozzles for the spray wand are stored in the nozzle holder (B) on the panel assembly (A). Colors on the panel identify nozzle location and spray pattern. Refer to the following chart to choose the correct nozzle for the job to be performed.
10
