English
Troubleshooting Guide
This section provides a list of the more frequently encountered malfunctions, their causes and corrective actions. The operator or maintenance personnel can perform some corrective actions, and others may require the assistance of a qualified DeWALT technician or your dealer.
Problem |
| code |
Engine will not start | 1, 2, 3, 4, 5, 6, 7, 8, 29 | |
(refer to the engine's instruction manual for further engine troubleshooting) | ||
No or low pressure (initial use) | 9, 10, 11, 12, 13, 14, 15, 16 | |
Will not draw chemicals | 16, 17, 18, 19, 20, 22 | |
No or low pressure (after period of normal use) | 21, 23, 24 | |
Water leaking at gun/spray wand connection | 25, 26 | |
Water leaking at pump | 25, 26, 27, 28 | |
Pump Pulsates | 12 | |
| Troubleshooting Codes | |
Code | possible cause | POSSIBLE SOLUTION |
|
|
|
1 | No fuel. | Add fuel. |
|
|
|
2 | Low oil. | Add required amount of oil. |
|
|
|
3 | Pressure builds up after two pulls on the recoil starter or after | Squeeze gun trigger to relieve pressure. |
| initial use. |
|
|
|
|
4 | Choke lever in the No Choke position. | Move choke to the Choke position. |
|
|
|
5 | Spark plug wire not attached. | Attach spark plug wire. |
|
|
|
6 | Engine ON/OFF switch in OFF position. | Place engine ON/OFF switch in on position. |
|
|
|
7 | Choke lever in the Choke position on a hot engine or an engine | Move choke to the No Choke position. |
| that has been exposed to thermal heat for a long period of time. |
|
|
|
|
8 | Fuel valve closed. | Move the fuel valve lever to the Open position. |
|
|
|
9 | Spray wand not in high pressure. | See Spray Wand Nozzles under Operation. |
|
|
|
18
