DeWalt DPD3100 instruction manual To Remove Tires, sTORAGE Engine, Pressure Washer, Pump, English

1. Remove the filter screen (U) by grasping the end and removing it from water inlet of pump.

2. Clean filter by flushing it with water on both sides.

3. Reinsert filter into water inlet of pump. Cone	U
side faces out.
NOTE: Do not operate pressure washer without
flter properly installed.

To Remove Tires

1. Using a 1/8" hex head wrench loosen set screw in hub collar.

2. Slide hub collar from axle and remove the tire.

sTORAGE Engine

Consult the engine instruction manual for the manu­fac­tur­er's­ recommendations for storage.

Pump

The manufacturer recommends using a pump protector/winter- izer, such as DeWALT winterizer (DP80) when storing the unit for more than 30 days and/or when freezing temperatures are expected. DeWALT winterizer (DP80) is availabe at the store where the pressure washer was purchased. If a pump protector/ winterizer is not available, RV antifreeze can be used as outlined in the following steps.

NOTE: Using a pump protector/ winterizer or RV antifreeze helps to provide proper lubrication to the internal seals of the pump regard- less of temperature or environment.

1.Obtain a funnel, 6 oz. (170 mL) of RV antifreeze and 16–36" (40–91cm) of garden hose with a male hose connector attached to one end.

CAUTION: Risk of property damage. Use only RV antifreeze. Any other anti­freeze­ is corrosive and can damage pump.

2. Disconnect spark plug wire.

3. Connect length of garden hose to water inlet of pump.

4.	Add RV antifreeze to hose as
	shown.
5.	Pull engine starter	rope	slow-
	ly several times until anti­freeze­
	comes out of high-pressure hose
	connec­tion­ of pump.
6.	Remove garden	hose	from
	water inlet of pump.

7. Reconnect spark plug wire.

Pressure Washer

1.Drain all water from high- pressure hose, coil it and store it in cradle of the pressure washer handle.

2.With nozzle pointed down and the spray gun and wand in a

vertical position, squeeze trigger to drain all water from spray gun and wand. Store in gun holder.

3.Store chemical hose so it is protected from damage­.

4.If space is needed, handles may be removed and attached as shown.

English

15