NOTE: This detector has been designed to be used only with a rotating laser. The detector will not work with a stationary beam laser level.

2.Turn the detector on by pressing the power/volume button (Z).

3.Adjust the volume as desired as described in the Detector Controls.

4.Position the detector so that the detector window (U) is facing the laser beam produced by the rotary laser. Move the detector up or down within the approximate area of the beam, until you have centered the detector. For information about the display window indicators and the audible signal indicators, refer to the table titled Indicators (Fig. 11).

5.Use the marking notches (DD) to accurately mark the position of the laser beam.

FIG. 12

 

 

 

II

 

 

EE

 

 

 

 

 

FF

HH

 

 

 

DD

 

 

 

 

GG

 

JJ

 

 

 

MOUNTING ON A GRADE ROD (FIG. 12)

1.To secure your detector to a grade rod, first attach the detector to the clamp by pushing in on the clamp latch (EE). Slide the

tracks (FF) on the clamp around the rail (GG) on the detector until the latch (HH) on the clamp pops into the latch hole (II) on the detector.

2.Open the jaws of the clamp by turning the clamp knob (JJ) counterclockwise.

3.Position the detector at the height needed and turn the clamp knob clockwise to secure the clamp on the rod.

4.To make adjustments in height, slightly loosen the clamp, reposition and retighten.

Detector Cleaning and Storage

Dirt and grease may be removed from the exterior of the detector using a cloth or soft, non-metallic brush.

The DEWALT Digital Laser Detector is waterproof. If you should drop the detector in mud, wet concrete, or a similar substance, simply hose the detector off. Do not use high pressure water, e.g., from a pressure washer.

The best storage place is one that is cool and dry–away from direct sunlight and excess heat or cold.

Detector Service

Except for batteries, there are no user serviceable parts in the Digital Laser Detector. Do not disassemble the unit. Unauthorized tampering with the laser detector will void all warranties.

Detector Troubleshooting

THE DETECTOR WILL NOT TURN ON.

Press and release the power/volume button.

Check to see that the battery is in place and in the proper position.

If the detector is very cold, allow it to warm up in a heated area.

English

17

Page 19
Image 19
DeWalt DW079 Detector Cleaning and Storage, Detector Service, Detector Troubleshooting, Mounting on a Grade ROD FIG