DeWalt DW079 instruction manual Repairs, Three Year Limited Warranty

Distance between walls	Allowable Error
L = 50 ft. (15.3 m)	1/8" ( 3 mm)
L = 75 ft. (22.9 m)	3/16" (4.5 mm)
L = 100 ft. (30.5 m)	1/4" (6 mm)

LEVEL CALIBRATION CHECK (Y-AXIS)

Repairs

The charger is not serviceable. There are no serviceable parts inside the charger.

To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustments should be performed by a DEWALT factory service center, a DEWALT authorized service center or other qualified service personnel. Always use identical replacement parts.

English

Repeat the procedure above, but with the laser unit positioned so				Three Year Limited Warranty
the Y-axis is pointed directly toward the walls.				DEWALT will repair, without charge, any defects due to faulty
PLUMB ERROR CHECK (FIG. 19)		FIG. 19		materials or workmanship for three years from the date of purchase.
				This warranty does not cover part failure due to normal wear or
1. Using a standard plumb bob as
			MARKS	tool abuse. For further detail of warranty coverage and warranty
a reference, mark the top and			ON	repair information, visit www.dewalt.com or call 1-800-4-DEWALT
bottom of	a wall. (Be sure to
			WALLS	(1-800-433-9258). This warranty does not apply to accessories or
mark the wall and not the floor				damage caused where repairs have been made or attempted by
and ceiling.)
				others. This warranty gives you specific legal rights and you may
2. Position the rotary laser securely
				have other rights which vary in certain states or provinces.
on the	floor approximately			In addition to the warranty, DEWALT tools are covered by our:
3' (1 m) from the wall.
				1 YEAR FREE SERVICE
3. Turn the laser on, and point the
				DEWALT will maintain the tool and replace worn parts caused by
dot at the mark on the bottom
				normal use, for free, any time during the first year after purchase.
of the wall. Then, using the up/
				2 YEARS FREE SERVICE ON DEWALT BATTERY PACKS
down arrows on the remote
control, rotate the dot upwards. If				DC9096, DC9091, DC9071, DC9360 and DC9280
the center of the dot scans over				90 DAY MONEY BACK GUARANTEE
the mark on the top of the wall,
				If you are not completely satisfied with the performance of your
the laser is properly calibrated.
				DEWALT Power Tool, Laser, or Nailer for any reason, you can return
NOTE: This check should be done				it within 90 days from the date of purchase with a receipt for a full
with a wall no shorter than the tallest				refund – no questions asked.
wall for which this laser will be used.
				21