FIG.3 | OPERATING HANDLE |
BRUSH INSPECTION CAP
| DUST SPOUT | BLADE GUARD |
|
| |
|
| ARBOR COVER |
BLADE WRENCH |
|
|
BEVEL STOP |
| LOCK DOWN PIN |
|
| |
OVERRIDE |
| FENCE |
|
| |
BEVEL STOP SCREWS |
| MITER ADJUSTMENT/LOCK |
|
| |
|
| HANDLE |
BEVEL |
|
|
ADJUSTMENT/LOCK |
| DETENT |
HANDLE |
| TRIGGER |
|
| TABLE |
BASE STABILIZER |
|
|
CAPACITY OF CUT
50° miter left, 60° miter right
48˚ bevel left and right |
|
|
| ||
|
| US Models | |||
Miter | Bevel | Max | Max | Max | Max |
____ | _____ | Height | Width | Height | Width |
______ | _____ | ______ | _____ | ||
0° | 0° | 4.3" | 12" | 4.3" | 12" |
45 L&R° | 0° | 4.3" | 8.5" | 4.3" | 8.5" |
0° | 45° L | 3.2" | 12" | 2.9" | 12" |
0° | 45° R | 1.7" | 12" | 1.7"` | 12" |
DRIVE |
|
|
|
|
|
120 Volt Motor
2200 Watts
15 Amp Motor
4000 RPM
Cut Helical Gears with Roller Bearings
60 Tooth Carbide Blade
Automatic Electric Brake
Optional Attachments/Accessories
WARNING: For safe operation, read instruction literature included with attachments/accessories.
Extension Kit: DW7080
Used to support long overhanging workpieces, the work
English
BASE
FIG. 4
TRIGGER SWITCH
SPINDLE LOCK BUTTON
KERF PLATE
MITER SCALE
LIFTING
HANDLE
BELT COVER SCREW
BELT COVER
RAILS
RAIL LOCK KNOB
THUMBSCREW
GROOVING STOP
FENCE ADJUSTMENT
KNOB (NOT SHOWN)
support is user assembled. Your saw table is designed to accept two work supports; one on each side. One set stores conveniently under the saw table.
Adjustable Length Stop: DW7051
Requires the use of one work support (see kit above). It is used to make repetitive cuts of the same length from 0 to 42" (0 to 106cm).
Material Clamp: DW7082
Used for firmly clamping workpiece to the saw table for precision cutting.
Crown Stop: DW7084
Used for precision cutting of crown molding.
Dust Bag: DW7053 (Some Models) Equipped with a zipper for easy emptying.
NOTE: Spout has a provision to attach a vacuum hose to collect sawdust. Proper orientation of dust bag is necessary to avoid interference during operation of saw. If interference cannot be avoided, dust bag must be removed. ALWAYS MAKE A DRY RUN WITHOUT POWER BEFORE MAKING ANY CUTS.
SAW BLADES: ALWAYS USE 12" (305mm) SAW BLADES. SPEED RATING MUST BE AT LEAST 4800 RPM. USE OF SMALLER DIAMETER BLADES MAY CAUSE SEVERE DAMAGE TO SAW.
Application | Blade | No. of | Type |
BENCH MOUNTING HOLES | HAND HOLDS |
5
