DeWalt DWD450, DWD460K Bail Handle (Fig. 4), Side Handle (Fig. 5)

English

INDICATOR DIAGNOSIS SOLUTION

FLASHING E-ClutchTM is

malfunctioning

(SERVICE)

Take the tool to an

authorized DEWALT

repair agent.

NOTE: If tool power is insufficient for normal drilling and LED does not

flash take tool to authorized DEWALT repair center.

Bail Handle (Fig. 4)

A bail handle is provided for carrying the tool and for use as an

additional handle. Assemble the bail handle in one of the positions

shown in Figure 4. When changing the location of the bail handle from

one position to the other, completely remove the two bail handle bolts

(E) securing it. Flip the handle over and reinstall.

FIG. 4

Side Handle (Fig. 5)

WARNING: To reduce the risk of personal injury, always operate

the tool with the side handle properly installed and tightened. Failure

to do so may result in the side handle slipping during tool operation

and subsequent loss of control. Hold tool with both hands to

maximize control.

REVERSEFORWARD

FIG. 3

SLIP CLUTCH

The DWD450 and DWD460 are each equipped with a slip clutch.

The clutch is active when the low speed (1) is selected. When the bit

or cutter bites into the workpiece, the clutch will slip and a ratcheting

sound will be heard. Release the trigger. Continued clutching of the

tool will reduce the life of this feature.

E-CLUTCHTM (DWD460)

The DWD460 is equipped with E-ClutchTM. This feature senses the

motion of the tool and reduces the motor torque to a manageable

level if necessary. The E-ClutchTM indicator (G) will illuminate to indicate

status.

INDICATOR DIAGNOSIS SOLUTION

OFF Tool is functioning

normally

Follow all warnings and

instructions when

operating the tool.

SOLID E-ClutchTM has been

activated (ENGAGED)

With the tool properly

supported, release trigger.

The tool will function

normally when the trigger

is depressed again and the

indicator light will go out