DeWalt DWE1622K manual Electrical Safety, Using an Extension Cable, Assembly and Adjustments

ENGLISH

Electrical Safety

The electric motor has been designed for one voltage only. Always check that the power supply corresponds to the voltage on the rating plate.

Your DEWALT tool is designed in class I (grounded) according to EN 61029. Earth wire is required.

WARNING: 115 V units have to be operated via a fail-safe isolating transformer with an earth screen between the primary and secondary winding.

If the supply cord is damaged, it must be replaced by a specially prepared cord available through the DEWALT service organisation.

Mains Plug Replacement (U.K. & Ireland Only)

If a new mains plug needs to be fitted:

•Safely dispose of the old plug.

•Connect the brown lead to the live terminal in the plug.

•Connect the blue lead to the neutral terminal.

•Connect green / yellow lead to the earth terminal.

Follow the fitting instructions supplied with good quality plugs. Recommended fuse: 13 A.

Using an Extension Cable

If an extension cable is required, use an approved 3-core extension cable suitable for the power input of this tool (see technical data).The minimum conductor size is 1.5 mm2; the maximum length is 30 m.

When using a cable reel, always unwind the cable completely.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of injury, turn unit off and disconnect machine from power source before installing and removing accessories, before adjusting or changing

set-ups or when making repairs. Be sure the switch is in the OFF position. An accidental start-up can cause injury.

Installing the Machine (fig. 2–5)

1.Assemble the feed handle.

2.Mount the drill guard (j).

3.Fit the lubrication system as necessary.

4.Place the machine on a clean, level and solid surface. Remove any particles that will obstruct full contact between the magnetic stand and the mounting surface.

5.Fit and tighten the safety chain (o).

MOUNTING THE FEED HANDLE ASSEMBLY (FIG. 1, 2)

The quick-release feed handle assembly can be mounted in one simple operation both to the left and the right of the machine.

1.Screw all three feed handles (f) into the hub (g).

2.Keep the button (p) depressed while inserting the hub shaft into the hole (q).

3.Release the button.

MOUNTING THE DRILL GUARD (FIG. 3)

1.Hold the guard (j) in front of the tool holder, aligning the slots in the guard with the holes in the machine.

2.Fit the screw (r) into the hole (s) located in the front of the frame.

WARNING: Always use the drill guard.

FITTING THE LUBRICATION SYSTEM (FIG. 1, 4)

The lubrication system can be used for horizontal drilling applications (the drill being used vertically).

1.With the coolant bottle (k) placed into the magnetic bracket (e), mount the magnetic bracket onto the steel strip (t) on either side of the tool.

2.Attach the coolant tube (l) to the coolant bottle:

a.Remove the nut (u) and thread it with the tube.

b.Slide the tube onto the nipple and tighten the nut.

3.Attach the tube to the quick-release connector

(v) on the gearbox

a.Push coolant tube (l) in to install.

b.To remove, push the collar on the connector

(v)in and pull the tube from the connector.

In order to use the lubrication system, the coolant bottle (k) must be filled with a sufficient amount of cutting fluid.

Filling the Coolant Bottle

1.Make sure the flow regulator (m) is closed.

2.Unscrew the cap (x).

3.Fill the container with cutting coolant diluted with water.

4.Screw the cap back on.

29