English
WARNING: Use of this tool can generate and/or disperse dust, which may cause serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved respiratory protection appropriate for the dust exposure. Direct particles away from face and body.
SAVE THESE INSTRUCTIONS FOR FUTURE USE Specifications
Amperes | 15 A |
Table Size | |
Miter Angle | 30° L&R |
Bevel Angle | 0° to 45°L |
Blade Size | 10" (254 mm) |
Max. Cut Depth, 0° Bevel | |
Max. Cut Depth, 45° Bevel | |
RPM, no load | 4800 |
Unpacking (Fig. 1)
WARNING: To reduce the risk of injury, | FIG. 1 |
| |
DO NOT connect the machine to the |
|
power source until the table saw is |
|
completely assembled and you have read |
|
the entire instruction manual. |
|
Open the box and slide the saw out, as |
|
shown in Figure 1. |
|
Carefully unpack the table saw and all |
|
loose items from the carton. Examine all |
|
parts to make sure that parts have not |
|
been damaged during shipping. If any parts |
|
are missing or damaged, contact your |
|
dealer to replace them before attempting |
|
to assemble the tool. |
|
FEATURES (Fig. 2, 3)
WARNING: Never modify the power tool or any part of it. Damage or personal injury could result.
Examine Figures 2 and 3 to become familiar with the saw and its various parts. The following sections on assembly and adjustments will refer to these terms and you must know what and where the parts are.
A. Table
B. Blade
C. Rip scale indicator D. Fine adjust knob E. Rail lock lever
F. Blade height adjustment wheel G. Bevel lock lever
FIG. 2 | K |
| Q |
A |
|
L
J
C
FIG. 3
V
T
S
T
R
S
E
D
G F
H
P
B
M
N
U
O
I
H. ON/OFF switch I. Mounting holes J. Miter gauge
K. Blade guard assembly
L. Riving knife/blade guard release lever
INTENDED USE
This table saw is designed for professional ripping, crosscutting, mitering, beveling and non
DO NOT use for cutting metal, cement board, or masonry.
DO NOT use under wet conditions or in presence of flammable liquids or gases.
DO NOT let children come into contact with the tool. Supervision is required when inexperienced operators use this tool.
4