Glossary
Bypass mode: Allows water to
Chemical hose: Feeds cleaning agents into the pump to mix with the water. Refer to Chemicals and Cleaning Solvents.
Chemical injection system: Mixes cleaners or cleaning solvents with water to improve cleaning effectiveness.
Choke control: Opens and closes carburetor choke valve.
CU: Cleaning Units. GPM multiplied by PSI. (GPM x PSI = CU)
Fuel valve lever: Opens/closes connection between fuel tank and carburetor.
GPM: Gallons Per Minute. The unit of measure for the flow rate of water.
PSI: Pounds per Square Inch. The unit of measure for water pressure. Also used for air pressure, hydraulic pressure, etc.
Thermal relief valve: When the temperature inside the pump rises too high the valve will open and release a gush of water in an effort to lower the temperature inside the pump. The valve will then close.
Water supply: All pressure washers must have a source of water. The minimum requirements for a water supply are 20 PSI and 5 gallons per minute.
Troubleshooting Guide
This section provides a list of the more frequently encountered malfunctions, their causes and corrective actions. The operator or maintenance personnel can perform some corrective actions, and others may require the assistance of a qualified DEWALT technician or your dealer.
Problem | Code |
Engine will not start | 1, 2, 3, 4, 5, 6, 7, 8 |
(refer to the engine's instruction manual for further engine troubleshooting) |
|
No or low pressure (initial use) | 9, 10, 11, 12, 13, 14, 15, 16, 36 |
Will not draw chemicals | 16, 17, 18, 19, 20, 21 |
No or low pressure (after period of normal use) | 22, 23, 24, 36 |
Water leaking at gun/spray wand connection | 25, 26 |
Water leaking at pump | 25, 26, 27, 28 |
Oil leaking at pump | 29, 30, 31, 32, 33, 34, 35 |
Pump Pulsates | 12 |
English
17
