Configuring Ports for RealPort: Command Line
This section describes how to configure RealPort ports from the command line.
Procedure
Use this procedure to use the command line to configure PortServer TS 8/16 for RealPort.
This procedure assumes that you have signed on as root and have or will
•Install RealPort software on each RealPort host. See the appropriate RealPort documentation for more information.
•Properly cabled PortServer TS 8/16 ports and devices.
•Set up the devices connected to PortServer TS 8/16 ports
1.Configure the RealPort TCP port by entering the following command: set tcp realport=771
2.Configure PortServer TS 8/16 ports by entering the following command: set ports range=range dev=rp
where range is the range of ports to which this command applies Example: set ports range=2 dev=rp
Example
In this example, all ports are configured for RealPort.
set tcp realport=771
set ports range=* dev=rp
Configuring Ports for RealPort: Command Line |
