Running PortServer TS 8/16 POST
Use these topics to run PortServer TS 8/16 power on self test to validate the PortServer TS 8/16 hardware.
Procedure: Running the POST Using the LEDs
1.Power on the PortServer TS 8/16.
2.Use the following table to interpret the output from the LEDs.
If ... | Then... | |
|
| |
The power LED blinks immediately | A DHCP error has occurred and the | |
PortServer TS 8/16 was not assigned an | ||
after POST | ||
IP address. | ||
| ||
|
| |
Any of the other four LEDs blink | A hardware component failed. | |
immediately after POST, | ||
| ||
|
|
Procedure: Running the POST from a Terminal
1.Connect a terminal to the first serial port on the PortServer 8/16.
2.If the port configuration was changed, configure the terminal to match the port settings. If the port is still using the default configuration, configure the terminal to use the following settings:
•
•9600 baud
•
•1 stop bit
•No parity
3.Reboot the PortServer TS 8/16 and press v when the LEDs begin to blink. POST output appears on the terminal screen.
PortServer TS 8/16 Troubleshooting |
