Operation
C. Manual Control Buttons
The Manual Control Buttons operate the fireplace levels sequentially (from off): flames only; to flames and low heat; to flames and high heat.
The level is increased every time the “I” button is pressed, and the fireplace can be turned off at any point by pressing the “O” button.
Resetting The
Temperature Cutoff
Switch
Should the heater overheat, an automatic switch will turn the heater off and it will not come back on without being reset. The temperature cutoff switch can be reset by unplugging the unit, waiting five (5) minutes and plugging the unit back in.
CAUTION: If you need to continuously reset the heater, unplug the unit and call Dimplex customer service at
Remote Control
The fireplace is supplied with a radio frequency remote control. This remote control has a range of approximately 50 feet (15.25
Figure 10
On
Button 
Off Button
Plastic
Strip
Battery
Cover
m), it does not have to be pointed at the fireplace and can pass through most obstacles (including walls). It is supplied with one
of hundreds of independent frequencies to prevent interference with other units.
Remote Control Usage
The remote control operates the fireplace levels sequentially (from off): flames only; to flames and low heat; to flames and high heat. The level is increased every time the ON button is pressed on the remote control and the fireplace can be turned off at any point by pressing the OFF button.
!Note: Before attempting any operation with the remote, pull the plastic insulator strip out from between the remote casing and
13
