Operation
battery cover (Figure 10).
Remote Control Initialization/ Reprogramming
If the remote control or remote control receiver has been replaced, follow these steps to initialize the remote control and receiver:
1.Ensure that power is supplied through the main service panel.
2.Turn On/Off Switch to “ I ” (Figure 9A).
3.Move the
(Figure 9B).
4.Press and hold the Manual
Control Button marked “ I ” for five (5) seconds (Figure 9C). After five (5) seconds, there is a 10 second window to press any button on the remote control.
5.Press any button on the remote control within that 10 seconds.
This will synchronize the remote control and receiver.
!NOTE: You will have only 10 seconds to perform this last step.
Failure to do so will result in these steps needing to be followed
again.
Battery Replacement
To replace the battery:
1.Slide battery cover open on the remote control (Figure 10).
2.Install one (1)
3.Close the battery cover.
Battery must be recycled or disposed of properly. Check with your Local
Authority or Retailer for recycling advice in your area.
14 | www.dimplex.com |
