Dimplex DF1136L, DF1135M owner manual Screw Wall Bracket

Fireplace Installation

CAUTION: Ensure that the top of the unit is at least 610mm (24") from the ceiling or any object (i.e. Electrical receptacles) that may obstruct or be susceptible the flow or temperature of air out of the unit.

CAUTION: High temperature, keep electrical cords, drapery, and other furnishings at least

3 ft (0.9m) from the front of the heater and away from the side and rear.

2.The wall-mounting bracket must be mounted to at least two (2) wall studs. Studs should be accessed through two (2) wall-bracket holes in one of the following combinations: A&F, B&D, or C&E (Figure 1).

!NOTE: Wall anchors must

Figure 3	Wall anchor
Screw
	Wall
	bracket

be installed in the appropriate wall locations to fasten the wall bracket through the remaining holes. (Figure 2) For example, if you plan to secure the bracket to studs through holes A&D, install anchors centered on holes B and C.

3.Hold the wall-mounting bracket on the wall and mark the location of ONE (1) of the mounting holes.

4.Place the bubble level onto the top of the wall-mounting bracket.

5.Adjust the wall-mounting bracket so the bubble on the level is centered between the two black lines.

6.Mark three (3) other mounting screw locations, on the wall, ensuring that the wall bracket stays level.

7.Install the supplied wall anchors on the drywall marked locations by placing a #2 Phillips screwdriver into the recess of the anchor.

8.Press the anchor into the wall in the desired marked position while turning the anchor clockwise until it is flush with the wall.

9