Quick Reference Guide

1.Before using the fireplace verify:

Are the circuit breakers for the unit on?

Are the light bulbs loose? (To check, follow the instructions for replacing the light bulbs under the maintenance section of this manual)

2.If you have any technical questions or concerns regarding the operation of your electric fireplace, or require service contact customer service.

3.The heater may emit a slight, harmless odor when first used. This odor is a normal condition caused by the initial heating of internal heater parts.

Fireplace Installation

Site Selection

The unit is packaged with two types of mounting options:

Wall mounting, Surface

Pedestal

!NOTE: A 15 Amp, 120 Volt circuit is required. A dedicated circuit is preferred but not essential in all cases. A dedicated circuit will be required if, after installation, the circuit breaker trips or the fuse blows on a regular basis when the heater is operating. Additional appliances on the same circuit may exceed the current rating of the circuit breaker.

WARNING: Ensure the power

cord is not installed so that it is pinched or against a sharp edge and ensure that the power cord is stored or secured to avoid tripping or snagging to reduce the risk of fire, electric shock or injury to persons.

Construction and electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk of fire, electric shock and injury to persons.

Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire, electric

7

Page 7
Image 7
Dimplex DF1136L, DF1135M owner manual Quick Reference Guide, Fireplace Installation